Services
4OUR

4OUR / 01

Fire alarm installation in Tashkent

We install and commission automatic fire alarm systems. Equipment, cable routes and settings come together as a working system based on the agreed design and the needs of your site.

Artistic equipment illustration in the 4OUR signature orange4OUR · Fire alarm installation

Scope of work

The scope depends on room readiness, design documentation and equipment. We first establish what has already been completed and what is needed to commission the system.

01

Equipment and cabling

Installation of detectors, control equipment and cable lines in accordance with the agreed documentation.

02

Connections and settings

Connecting devices, configuring equipment and checking communication between system components.

03

Commissioning

Checking signals, indications and interaction with other systems as specified in the design.

04

Handover

Recording completed work and test results. Recommendations for subsequent operation and maintenance.

4OUR / Fire alarm installation

Installation: from cable routes to devices

We install fire alarm equipment to the agreed documentation. Before work starts, we check room readiness, cable routes, device locations and access to work areas.

  • Lay and label cable runs, install fixings and the specified protection for the routes.
  • Install detectors, manual call points, control panels and auxiliary devices included in the agreed scope.
  • Connect circuits and power supplies, check connections and confirm that installed sections are ready for configuration.

Result: Installed and labelled system sections, a record of completed work and a list of issues to resolve before commissioning.

4OUR / Fire alarm installation

Commissioning: checking how the system works

After installation, we configure the equipment and test it against agreed scenarios. At an occupied site, test times and coordination with responsible staff are arranged in advance.

  • Check panel settings, device addressing and whether labels match the actual equipment locations.
  • Check signal reception and display, fault messages and interfaces with other systems specified in the design.
  • Record test results, address issues within the agreed scope and carry out repeat checks.

Result: Tested operating scenarios, recorded results and a list of outstanding issues. The contract defines the documentation to be handed over.

From the task to a clear result

  1. 01

    Understand the site

    Tell us about the building, equipment and task. We clarify the available information and whether a site inspection is needed.

  2. 02

    Agree the scope

    We agree the work, materials, documents, timing and price before starting.

  3. 03

    Complete and document

    We carry out the agreed work, check the result and hand over the documents and recommendations specified in the contract.

What determines the price

Floor area and use, device count, cable length and routing, finishing work and integration requirements affect the price. We prepare an estimate after clarifying the inputs and scope.

Before work begins

Can we contact you before renovation is complete?

Yes. The stage of renovation affects cable routes and installation sequencing. We will check room readiness and access to work areas.

What do you need for an estimate?

Floor plans, a design if available, the intended use of the site and your preferred schedule. If these are not ready, we can start by clarifying the requirements.

Do you maintain the system after installation?

Yes. Fire alarm maintenance is a separate 4OUR service. Checks and ongoing service terms are agreed separately.

4OUR / Contact

Let’s start with your site.

Tell us where the site is, how it is used and what you need. If you have floor plans or an equipment list, attach them to your enquiry.

← All services on the homepage